240 | C1Series de grifería · Instalación M2-E Instalación 4. CASOS DE FUNCIONAMIENTO INCORRECTO CAUSES OF A FAULTY OPERATION ES Problema Posible causa Solución Objeto obstruye el campo de detección Comprobar que no hay objetos en el campo de detección Manos colocadas fuera del área de detección Colocar las manos enfrente del visor y dentro de la dis- tancia de detección ajustada El visor no está completamente limpio Comprobar que el visor esté limpio El agua no fluye Llaves de regulación cerradas Comprobar que las llaves de regulación estén abiertas No hay alimentación de agua Comprobar que dispone de alimentación de agua Comprobar que las pilas están en buen estado y colo- Fallo de alimentación eléctrica cadas correctamente o fuente de alimentación correcta- mente conectada El visor no está completamente limpio Comprobar que el visor esté limpio Detecciones Ajuste de distancia de detección muy largo involuntarias o para las condiciones de instalación Reducir la distancia de detección el grifo cierra más tarde de lo Condiciones ambientales no óptimas para el Debe evitarse la instalación de este grifo en lugares don- esperado uso del grifo con detección infraroja de los rayos solares puedan incidir directamente sobre el visor Comportamien- Comprobar buena conexión de la alimentación eléctrica to errático y Alimentación eléctrica intermitente y que la línea AC no se ha tomado del interruptor de la aleatorio iluminación EN Problem Possible cause Solution An object is blocking the detection field Check that there are no objects in the field of detection. Hands are placed outside detection range Place hands in front of detection window within adjusted detection range Water does not Detection window is not completely clean Check that the detection window is clean come out Regulating cocks closed Check that the regulating cocks are open No water flow Check that mains water is available Electric supply failure Check that batteries are in good condition and are fitted correctly or power supply properly connected Detection window is not completely clean Check that the detection window is clean Involuntary shut Detection range of sensor system set too high Reduce detection range off or late shut- for local conditions ting off of tap Local conditions are not suitable for use of This tap should not be fitted in places where sunlight can infrared detection faucet fall directly on the detection window Erratic and alea- Intermitent electric supply Check that electric supply connection is correct and that tory behavior it is not connected to the illumination switch