C6 Electronic flush valves · Installation | 827 Euret-E Installation, use and maintenance 3Installation Refer to the following diagram to drill fixing holes, insert fisher bolt and install the hanging bracket. Pay attention to the relative position between brackets and inlet/outlet p ipes to avoid interference. 15mm 8mm Horizontal outlet inner diameter Ø52 Note: If the urinal cannot be hung on the bottom bracket, just put a 6 mm thick washer between the bracket and the wall. (mm) Follow the bottom diagram to install the angle valve and discharge pipe. To make the installation easier, we suggest the use of some lubricant (without erosion to rubber and pipe ) onto the inside of the discharge pipe. Make sure that the supplied water is clean, with no impurities, sand or with a degree of alkalinity that might damage the product. Maximum distance from wall 102 mm Connect to main power supply(Only A35945M..0 , A35945T..0) 1. Locate the switching power inside the valve unit and pass the ac cable through the hole. 2. Connect switching power cable and main power supply into the cable connection box. 3. C he installation of the urinal on the wall.lose cables connection box and locate it on a free space in order not to interfere witht 1. For your safety, do not connect the power until the installation has been completed. 2. Do not connect the power cable to the valve box. 3. Power supply is supposed to be installed with appropriate thermal fuse (10/home/webapps/asp_fr/data/asp/publications/roca-general/export-(export)/faucets-technical-manual-201615Amp) or other protection devices. 4. If you use any other method to connect the cable of the transformer to the power, please make sure it is duly firm and insulated. 2 1 Switch power Input : AC100-240V/home/webapps/asp_fr/data/asp/publications/roca-general/export-(export)/faucets-technical-manual-2016 AC power assembly 3 Close 438 313 R1/2" 860 50 23 255 188 553