C6 Electronic flush valves · Installation | 829 Euret-E Installation, use and maintenance 5Installation procedure Installation of front panel and battery case (A35945E..0 , A35945S..0) Take out the panel kit and battery kit from the accessory box, and pull the cap open. Follow this diagram to place the four AA batteries, (Please take into account the position of the positive and negative ends of the batteries during installation.) Once installed, close the cap. Cap 4 pieces of AA battery • Make sure that the cable is correctly positioned and keep the cable in the lower part. Battery box For a correct functioning, make sure that the connectors are correctly • Battery housing connected. • Check the direction of the connector and do not force the connection. Installation of panel and battery box (A35945E..0 , A35945S..0) Installation of panel and AC Power Assembly (A35945M..0 , A35945T..0) Place the power supply into the control box. • Pay attention to the installation direction and keep the control wire downward. • Pay attention to the connection of the connector. • Be aware of the direction of cable connection, it should not be forced to be installed. Use a screwdriver to attach the panel to the control box, and finally insert the IR filter into the panel to finish the installation. • Pay attention to the installation direction and keep the control wire downward. • Pay attention to installation direction of the IR filter. • Do not push or drag the IR filter forcefully to avoid damaging. NOTE: In case of maintenance, insert a needle (Not included) into the hole of IR filter and remove the IR filter. Use a screwdriver to release two screws and remove the panel.