832 | C6 Electronic flush valves ยท Installation Euret-E Installation, use and maintenance 10Cleaning and Maintenance Adjust the water flow rate 1. Use a needle or a sharp object (not provided) to extract the IR filter. Use a screwdriver to disassemble the screws from the bracket. 2. Use a screwdriver to adjust the flow rate knob as shown in the following image. Cle aning of the filter The sensor valve is equipped with a filter, but if it is dirty this may affect the volume of the flush. We recommend the cleaning of the filter. 1. Use a needle or a sharp object to extract the IR filter. Use a screwdriver to disassemble the screws of the bracket. 2. Use a screwdriver to close the flow regulator. 3. Remove the filter and clean it. 4. After cleaning the filter, reinstall it and open the flow regulator. Filter ON Extract the filter Clean the filter Reinstall the filter Adju st the water flow rate OFF NOTE: It is recommended only disassemble two screws at one time while disassembling fixing bracket. Please avoid taking out four screws at the same time, this will cause difficult installation. Troubleshooting Symptom Probable Cause Action 1. No batteries or wrongly installed (A35945E..0 , A35945S..0) 1. Check the batteries. No response 2. A/C power s ource outage or pow er cut 2. Check the transfomer. (The indicator not on) (A35945M..0 , A35945T..0). 3. Remove any objects located in front of No flushing 3. There are objects in front of the sensor or the the sensor. IR filter is dirty. 4. Clean the IR filter. 4. The wire connection is incorrectly connected. 5. Revise the connection of the cables. There is response 1. The installation is just finished 1. Wait 60 seconds . (The indicator flickers) 2. The inlet valve is not fully opened. 2. Fully open the inlet valve No flushing or bad flushing result 1. The flow regulator is not open enough. 1. Fully open the inlet valve. Not enough water 2. The filter is blocked. 2. Clean the filter 3. The water pressure is too low. 3. Contact the water supplier Flush cannot be stopped. There is dirt inside the solenoid valve. Clean the water filter. (The indicator not flickering) No flushing but the indicator flickers The batteries are run out (A35945E..0 , A35945S..0) Change the batteries. Other Please contact the dealer for further service